HYOSUNG Comet 650, Manual

Page: 49 / 90

48
10. Operate the engine a few seconds by
idling speed.
Inspect the oil leakage at the oil filter cap.
11. Confirm the oil level with the oil level lens
after waiting about a minute next to stop-
ping the engine.
The oil level is located between the
“
Lower line(L)
”
and the
“
Upper line(F)
”
.
When below the
“
Lower line(L)
”
, refill the
oil between the
“
Lower line(L)
”
and the
“
Upper line(F)
”
.
9. Replace the drain plug and tighten it
securely. This time, insert the gasket nec-
essarily. Pour fresh oil through the filler
hole. Approximately 3,200
㎖
of oil will be
required.
Approximately 3,000
㎖ ㎖
of oil must be
required when changing oil only without
replacing the oil filter.
CAUTION
In case of the engine oil pouring exces-
sively, the engine output being made
insufficient.
Be careful not to pour engine oil.
CAUTION
COOLANT
◉ ◉
COOLANT LEVEL
The coolant should be kept between the
“
F
”
(FULL) and
“
L
”
(LOW) level lines in the
reservoir tank at all times. Inspect the level
every time before riding while the motorcy-
cle vertically. If the coolant is found lower
than the
“
L
”
level line, add properly mixed
coolant in the following way :
If the reservoir tank is emptied, pour the
engine coolant to the reservoir tank and
radiator.
1. Remove the front and rear seat.
2. Remove the filler cap and add properly
mixed coolant through the filler hole
until it reaches the
“
F
”
line.
Refer to the FUEL, ENGINE OIL AND
COOLANT RECOMMENDATION section
(14 page).
COPYRIGHTED