HydroTherm HeaetNet V3 KN-10, User Information

Page: 90 / 108

OPERATION HeatNet Control V3 2.x
Page 90
KN HeatNet Control Run Screen
Hold theBACK
button down
for 5 seconds
to enter the
SETUP menus
CALIBRATE
RUN %100 OUTSIDE
RUN %100
SUPPLY
RUN %100
RETURN
RUN %100 HEADER
RUN %100
SYSTEM SET
RUN %100 *STATUS
START 0
STOP
0
RUN %100
BLRS FIRING
1_2______P
_________2
RUN %100 MIN VFD
25%
CALIBRATE
RUN %100
IGN VFD
30%
CALIBRATE
RUN %100 MAX VFD
90%
CALIBRATE
RUN %100
DELTA TEMP
RUN %100
DELTA TEMP
CALIBRATE
MASTER:SYSTEM SET
MEMBER: LOCAL SET
SYSTEM SET
RUN %100
157°F
RUN %100
25°F 25°F
90°F
50°F
162°F
142°F
158°F
160°F
DHW SETPT
DHW TEMP RUN %100
157°F
RUN %100
160°F
DHW SETPT
DHW TEMP
RUN %100
CALIBRATE
CALIBRATE
CALIBRATE
RUN %100
NA
SYS RETRN
CALIBRATE
RUN %100
CALIBRATE
RUN %100
5853
TACH
CALIBRATE
RUN %100
LOCAL SET
158°F
The SETPOINT can be adjusted by
pressing and holding the SELECT
button until the SETPOINT flashes.
Then use the UP and DOWN buttons
to change the value. Pressing the
SELECT button saves the value.
Press the UP or DOWN Arrow Keys
to navigate the display screen.
If the Header Sensor is present the
menu will display
SYSTEM SET ,
otherwise it will display LOCAL SET .
RUN %100
RUN %100
NA
SYS RETRN
RUN %100
5853
TACH
The BLRS FIRING screen is used by the Master
boiler to indicate which boilers are firing. If the
boiler # is blinking a problem exists on that boiler.
If a symbol is displayed, that positions boiler
was detected. If a ‘D’ is displayed, the Master is
controlling that boiler as a DHW boiler.To the far
right the current active system pump is displayed
vertically as P1 or P2 (Pump 1 or Pump 2)