Programming the load valve
Note:
You can only program the load distance if it is
INACTIVE.
You can define the operating modes in the
Load valve (1/2)
dialog.
1
Press to
open the menu.
2
Use
to highlight
Special Applications
and press
.
3
Use
to highlight
Load distance
and
press .
4
Use
to highlight
Parameter
and press
.
You can define the behaviour of the load valve in the dialog:
Operating mode
Press to select
the desired operating mode:
Ramp
The valve follows the curve of a defined ramp
see
programming operating mode ramp
Sine
The valve follows a sinusoidal curve.
see
programming operating mode sine
Inactive
The load valve is switched off.
Manual
The proportional valve of the load valve is operated manually via
the function keys
Mode
Press
and s
elect between the following options.
CYCLICAL
Ramp/sine is repeatedly run down. The number of repetitions is
defined as
Nbr. of cycles
.
SINGLE VAL
Ramp/sine is run exactly once.
Nbr. of cycles
If the load is repeated cyclically, enter the number of the repetitions.
Programming the operating mode manual
In this operating mode it is not necessary to program additional parameters.
In manual mode, the position of the proportional valve is set by pressing the function keys while the
load valve is in operation.
Save and exit the setting with F5 .
