- 6 -
The operator is in a position to reset the relative operating hours by pressing the button
once and the relative operating hours counting from the last reset are shown in the display.
The operating hours can be cleared by pressing the button
once or the buttons also is used
to reach and return to the previous display.
Clearing the relative operating hours results in an automatic store and monitoring in line 2 of the
actual time of clearing.
Date / Time
The operator can alter the internal timer and the date as described below. The main menu Date /
Time must initially be retrieved, whereby the display shows the actual setting.
If the setting is to be altered, press the button
and should no modification be requested, the
sub-menu can be left by pressing the button
.
The active field that can be altered is marked with a line underneath. Alter the setting by pressing
the buttons
or
until the desired figure is visible. The setting is finished once the Cursor
is not flashing anymore. The mode is achieved by pressing the corresponding button
. The
menu can be left by pressing the button
once.
NOTE:
If the button
is pressed during the modification phase, the input is interrupted
and the changed figures not be registered.
000015 oper. hours since
08.10.2001 14:50
000000 oper. hours since
10.10.2001 09:40
Date: Wed 10.10.2001
Time: 09:45
Date: Wed 10.10.2001
Time: 09:45
