INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS.
WARNING: WHEN USING YOUR HYDRO SYSTEMS TUB, BASIC PRECAUTIONS SHOULD BE FOLLOWED, SEE BELOW
1. DANGER: To reduce the risk of injury, do not permit children to use this unit unless they are closely
supervised at all times.
2. Use this unit only for its intended use as described in this manual. Do not use attachments not
recommended by the manufacturer.
3. Never drop or insert any object into any opening.
4. Do not operate this unit without suction cover installed.
5. The unit must be connected only to a dedicated electrical supply circuit that is protected by a Ground Fault
Circuit Interrupter (GFCI). The GFCI must be provided by the installer and should be tested on a routine
basis by the homeowner. To test the GFCI push the test button. The GFCI should interrupt power. Push the
RESET button. Power should be restored. If the GFCI fails to operate in this manner there is a ground
current fault, indicating the possibility of an electric shock. Do not use the tub. Disconnect the power and
have the problem corrected by a qualified service representative. Re-test the GFCI and only when it is
operating properly may the whirlpool tub be used.
6. A terminal is provided on the exterior of most equipment. To reduce the risk of electric shock, connect this
terminal to the grounding terminal of your electric service or supply panel with a conductor equivalent in
size to the circuit conductors supplying this equipment.
1.
DANGER: RISK OF ELECTRICAL SHOCK.
Connect only to a circuit protected by a ground fault circuit interrupter.
2. This unit should be installed by a qualified service representative. All electrical connections should be made
by a licensed electrician. Grounding is required.
3. The installation of Hydro Systems bathtubs must meet all applicable codes and regulations.
4.
READ ALL THE INSTRUCTIONS
before you begin the installation.
5.
INSPECT THE TUB
before you begin the installation. Inspect the following:
•
Is it the correct model? The corect size? The correct color?
•
If options or upgrades were ordered, are they complete and correct?
•
If the tub was ordered with components in non-standard locations, check to make sure they all are in their
correct locations.
•
Check all components to make sure no damage occurred during shipping.
•
For tubs with Tile Flange inspect for positive draft to bathing well.
2
IMPORTANT INSTALLATION INSTRUCTIONS
DO NOT INSTALL THE TUB if any of the above is not correct.
Contact the dealer where the bathtub was purchased or call Hydro Systems directly at
661-775-0686.
You will need to know the bathtub serial number attached to your warranty card and also located on
the back side of the bathtub when contacting Hydro Systems.
INSTALLATION INSTRUCTIONS
