installation
Wall Mount
1. Choose an installation location that is:
•
Within 1.5m (4.5 ft.) of the product containers.
•
At a reasonable height above the wash tank on the dish machine that allows for easy maintenance access.
•
Away from any direct sources of steam, water spray, and high temperatures.
•
Close enough to the dish machine electrical control panel to allow dispenser wiring without use of an external junction box (not
provided) wherever possible.
2. Use the mounting bracket to mark the appropriate mounting location and as a hole template to mark the securing holes.
3. Wall anchors are provided, please ensure they are appropriate to the wall/surface being mounted to.
4. Attach mounting bracket to mounting surface with hardware provided.
5. Hang unit on bracket.
Installing the Rinse Injection Fitting
1. Install the rinse injection fitting to conform to local plumbing codes.
2. The injection fitting is designed to fit global needs. It should thread directly into a 1/8” NPT (North America) or a BSP (Global) female
threaded connection. As an alternative to the threaded connection a barb fitting adapter is also included.
3. If the machine’s rinse plumbing is thin-wall pipe, use a saddle clamp with the 1/8” threaded hole.
4. If the machine already has a tapped hole to accommodate the fitting, skip to Step 8
5. Choose a location for the rinse injection fitting that is downstream from the vacuum breaker and at the proper height per local plumbing
codes. This point is either into the pressurized rinse line or upstream of the booster heater for the rinse water.
6. To create the threaded connection at your selected location, drill a 9 mm (11/32”) hole in the rinse plumbing at the injection location.
7. Tap the hole drilled in step 6 with a 1/8” tap (NPT or BSP depending on the region)
8. Install the injection fitting. Use thread sealant to ensure a leak-free assembly.
Installing the Detergent Injection Fitting
1. When choosing a mounting locating, make sure that the detergent infection fitting will be:
•
Above the water level of the filled wash tank.
•
Discharging detergent directly into the wash tank and not on top of any shelf areas or other obstacles that could prevent
detergent from falling directly into the wash tank.
2. Previously punched holes may be suitable but always confirm that the fitting is correctly placed. 10mm (3/8’’) holes are common in
Europe and 22mm (7/8’’) holes are common in North America. If an appropriate hole is present, go to step 4.
3. If a hole is not available already, drill a 10mm (3/8’’) hole at the center of your chosen detergent injection location on the dish machine
tank.
4. Remove the retaining nut from the supplied detergent injection fitting and gather the gaskets and washers supplied with the unit.
5. a. For a 10mm (3/8’’) hole insert the detergent injection fitting (with a rubber gasket) into the hole you drilled earlier.
b. For a 22mm (7/8’’) hole insert the detergent injection fitting (with a large rubber gasket backed by a large stainless steel washer).
6. From the inside of the machine install a second rubber washer, stainless backing washer if using a 22mm (7/8’’) hole, and the retaining
nut. Tighten finger-tight, then snug using a wrench.
CAUTION!
Do not over-tighten the plastic retaining nut.
