hydro-s Inverter 12, User And Service Manual, Page: 23 / 182

20
Press first, then press to check the “ User parameter from d0 to d11
Code Condition Scope Remark
d0 IPM mould temperature 0-120
℃
Real testing value
d1 Inlet water temp. -9
℃～
99
℃
Real testing value
d2 Outlet water temp. -9
℃～
99
℃
Real testing value
d3 Ambient temp. -30
℃～
70
℃
Real testing value
d4 Frequency limitation code 0,1,2,4,8,16 Real testing value
d5 Piping temp. -30
℃～
70
℃
Real testing value
d6
Gas exhaust temperature
0
℃～
C5
℃
(125
℃
)
Real testing value
d7 Step of EEV 0
～
99 N*5
d8 Compressor running frequency 0
～
99Hz Real testing value
d9 Compressor current 0
～
30A
Real testing value
d10 Current fan speed 0-1200
（
rpm
）
Real testing value
d11 Error code for last time All error code
Press first, then press to check the “ User parameter from P0 to P7
If needed, press second, then press or to adjust the current parameter.
(for example: Press first, then press to enter parameter P7 checking, and press second, then
press or to adjust the parameter P7 Inlet water temp. Correction from -9 to 9.)
Code Name Scope Default Remark
P0 Manual defrost 0-1 0 1 Manual defrosting mode, 0 Normal mode
P1 Working mode 0-1 1 1 Heating mode
，
0 cooling mode
P2 Timer on/off 0-1 0
1 Timer on/off is under function
，
0 Timer on/off is out of
function (The setting of P4 and P5 won’t work)
P3 Water pump 0-1 0 1 Always running
，
0 Depends on the running of compressor
P4 Current time HH:MM 00
：
00 0-23:0-59
P5 Timer on HH:MM 00
：
00 0-23:0-59
P6 Timer off HH:MM 00
：
00 0-23:0-59
P7
Inlet water temp.
correction
-9
～
9 0 Default setting: 0
NOTE: Under defrosting mode, P0=1.
After defrosting finished, it will be automatic enter Normal mode, P0=0.
6.2.4 System reset function
Press and in 10s, the system will reset and display “0000” on the controller.