10
Detailed Setup
Follow these simple steps for using Hydro Heater
TM
unit Complete Set-Up steps on previous pages.
CAUTION
Electrical Connection
“D” Batteries
• D cell battery compartment.
• These batteries start the
igniter automatically when
proper water pressure is
sensed by the heater system.
• If Heater doesn’t start, check
batteries and replace if
necessary..
Blue Adjusts Water Flow
Heater Temperature
Adjustment
WATER FLOW
• Rotate the Blue ring to the
right (+) setting. This increases
the flow of water through the
heater. Reducing the water
flow will increase temperature
but also increase the pressure
on the pump and drain battery
faster.
• Clockwise Increases Water
Flow
For Hotter Water
• To reach the hottest water temperature, the BOTH
KNOBS
will be rotated to the left.
• DANGER - SEE SCALDING WATER WARNING
• The resulting output water temperature is dependent on
the temperature of your source water
.
• Hydro HeaterTM unit will NOT maintain a constant
temperature when using in a recirculation system for the
Hydro Hammock. The water temperature will continue to
increase as the water in the Hammock increases.
• Hydro HeaterTM unit will not increase the water
temperature more than 35° over the temperature of the
source water.
• Connect the Battery System Connectors before use.
Unconnect Battery System Connectors when in transit to
eliminate the possibility that the on/off switch turns on
accidentally.
• Disconnect During storage to prolong the battery life.
Red Adjusts Flame
HEATER TEMPERATURE
• Rotate the Red ring to the
upright center position as a
starting place. This contol
knob increases the flame and
temperature of water through
the heater.
• ***Counter Clockwise
Increases Temperature.
DANGER: Scalding Water
The Water Temperature of the Hydro Heater
TM
will
not maintain a constant temperature when used in a
recirculating system.
When using to heat the Hydro Hammock constant
monitoring of temperature is required to maintain safe
temperatures.
Once the Hammock is at your preferred temperature you
can shut down the heater until you need to reheat the
water.
Drain Screw
• Grooved Screw used to Drain
Heater for Winterization and
Storage.
• Re-Tighten after draining.
D- Battery for Ignition of
Heater
Heater Drain Screw
Battery Indicator /
Charger Port
• Plug the smart charger here.
• Replace water resistant cap
when finished.
Battery Charger / Indicator
Port