2
Congratulations on your purchase of the Hydro-Well III 100 gallon water tank.
Years of experience, engineering, and planning have gone into the design and manufacturing
of the Hydro-Well III. We take a great deal of pride in the Hydro-Well III; our goal is no less
than your complete satisfaction.
This manual will provide users with the knowledge to properly install the Hydro-Well III.
Any questions pertaining to the operating or servicing of this unit should be directed to your
nearest Hydro-Force distributor.
This manual is written specifically for the Hydro-Well III manufactured by:
Hydro-Force Manufacturing
4282 South 590 West
Salt Lake City, UT 84123
801-268-2673
801-268-3856 FAX
Information in this manual is subject to change without notice and does not represent a
commitment on the part of Hydro-Force, its parent or affiliated companies.
CAUTION:
While the Hydro-Well III is designed for use with cold water, hot water from
residential or commercial building water heaters may be safely used if the incoming
water temperature is below 150ºF or 65ºC.
However, if you are using hot water, make sure the water temperature in the tank does
not exceed the temperature rating of your pump. Check with the pump manufacturer
or your distributor for information on the temperature rating of your pump.
Heated by-pass water from a truck mounted cleaner must not be circulated back to
the Hydro-Well III.
High incoming water supply pressure may flow through closed Float Valve. Observe tank
during filling and turn off water as soon as tank is full. In some areas an inline pressure
regulator may be required to prevent the Hydro-Well III from overflowing.
The Hydro-Well III should only be filled while the vehicle is parked on a level area.
Filling the tank while parked on an incline may prevent the Water Control Valve or
overflow ports from operating properly. This can cause the tank to overflow inside the
van or over-pressurize and damage the tank.
INTRODUCTION
