Hydac CSI-B-1, Operating Instruction

Page: 18 / 36

CSI-B-1 CSI-B-1 is detected by the PC
CSI-B-1 is detected by the PC
The PC detects the CSI-B-1 after the following steps have been carried out:
- USB driver is installed
- CSI-B-1 is connected with the PC via a USB cable
- the PC is switched on
-
the CSI-B-1 is equipped with voltage
You will receive the following message only after the first time the CSI-B-1 is
connected:
New hardware found
Installation ....
This completes the installation of the CSI-B-1.
Run the Windows DeviceManager as follows in order to determine the COM
interface at which the CSI-B-1 is now located.
Settings -> System Control -> System -> Hardware -> DeviceManager
DeviceManager
!
If the CSI-B-1 has been detected by the system, then this will be identified in the
DeviceManager with the corresponding COM interface (here: COM9).
Please make a note of this COM interface for yourself. This information will be
needed again when the HyperTerminal is opened.
HYDAC FILTER SYSTEMS GMBH en(us) Page 18 / 36
BeWa CSI-B-1 3424452b 2012-04-20 en-us.doc 2012-04-20