Hyd-Mech S-20DS, Use And Maintenance Manual, Page: 8 / 138

1--2 2
Use and maintenance manual S--20DS
Machine presentation
This machine is equipped with CCS (Cut Control System), which is a devicethat
consents a cut for each bow fall,with controlled descent speed: after having
positioned the head in the initial cutting point, the operator fastens the material
in the vice and presses the start button on the control board to start the band up.
The band begins to rotate and the head begins to descend. Its speed is adjustable
using the head descent speed adjuster positioned on the control board.
The head determines cutting of the material. Once the cut has been made, an end
run stops the cutting cycle, after which the head is raised manually ( or with the
optional hydraulic control unit for raising of the head).
After having fed the material again a new cutting cycle can be started by pressing
the button on the control board. In the AV version (Automatic Vice) a pneumatic
cylinder applied to the vice blocks the material in the jaws: the vice opening/clos-
ing key is found on the control board.
Machine specification
The anodised aluminium name plate is riveted on the side of the machine; the
same data are reproduced on the declaration of conformity included with this use
and maintenance manual.
When communicating with the Technical Service department, the model, serial
number and year of manufacture of the machine must be quoted.
CUTTING SPEEDS
Blade rotation speed mt/min 20 100
BAND SAW
Rated size mm
4500 x 27 x 0,9
Max/min blade length mm 4500 ± 40
Blade height mm
27
Blade width mm 0,9
Band saw tension Kg 1250
When choosing the cutting tool, if its dimensions do not correspond to those
included in the ”Rated size” section, check that the dimensions at least fall
within the admissible max/min specifications.
N.B.
Attention