Hyd-Mech S-20, User Manual

Page: 19 / 60

2.1
SECTION 2 – OPERATING INSTRUCTIONS
The operator control panel provides the operator with all the controls necessary to operate the saw after the
cutting angle has been set and the stock has been loaded and secured. All of the electrical functions and the
Feed Rate setting are operated from the control panel.
HYDRAULIC CONTROLS
FEED RATE KNOB - Controls feed rate of the head. This
rate can be set on the scale of 1
to 10. As the number increases so
does the feed rate.
HEAD CONTROL LEVER
HOLD -
Stops and holds the Head at the current
position.
FEED - The Head will descend at the rate set by
the Feed Rate knob.
DOWN - Allows for rapid approach of the blade to
the workpiece.
ELECTRICAL CONTROLS
FUSE- Check if power fails. Twist & pull to remove the
fuse.
COOLANT Switch -
2)) 1RFRRODQWÀRZ
21 &RRODQWÀRZZKHQEODGHLVUXQQLQJ
:$6+&RQVWDQWÀRZ
START Button - This button starts the saw blade. The
blade will not start with the Head in the
down position or if any safety interlock
switches (if equipped) are not closed.
STOP Button - Pressing the RED mushroom button will
STOP the blade.