Hyd-Mech H-22A, Operation And Maintenance Manual

Page: 23 / 130

Pg 2.8
H22
NOTE: Whenever a new job or new material is being loaded for production, the head height should be properly set
to clear the material, material positioned for a trim cut and the front vise (and auxillary vise is used) closed (in
"MANUAL MODE"). Before entering AUTO mode, the head should be "HOMED".
See function button description for .
AUTOMATIC OPERATION
When the AUTO/MAN button is pressed, the red indicator light above it will come on, and the blade will stop if
it has been running. The screen will change to the JOB display window as shown below and be ready for editing
or starting a new job. All manual functions will be disabled.
JOB DISPLAY WINDOW
PROCEDURE FOR EDITING OR STARTING A NEW JOB IN AUTO MODE
1) In AUTO mode, key in a job number from 0 to 99 and press If the job number has previously
been programmed, the QUANTITY REQUIRED (RQ), LENGTH (LTH) and QUANTITY CUT (CT) will be
displayed. The values displayed can be edited and the job will be stored in memory with the new values. To
navigate through the values, use the CURSOR keys.
NEW JOB VALUES
2) After the values are entered, press the CYCLE START button, the switch will illuminate, the display
window will prompt you to "SET MTL. HEIGHT". Using the head selector switch, position the head above the
work-piece.
3) After setting blade height, you will be prompted to "START THE BLADE FOR TRIM CUT"
4) After starting the blade, the head will descend for the trim cut and continue to complete the required job.
5) At the completion of the job, the machine will shut down.
ENTER
KERF
JOB 0 RQ 0
LTH 0.000 CT 0
Length
Blade Speed
Cut Quantity
Required Quantity
Job Number
Previously Cut
Length
Quantity JOB 99 RQ 10
LTH 15.000 CT 5
SET MTL. HEIGHT
& PRESS "ENTER"
START THE BLADE
FOR TRIM CUT
SFM 100 J1 RQ 2
LTH 5.000 CT 0
Display while head in
up position and
material advanced.
SFM 100 J1 RQ 2
FR 1.2 CT 0
Display while head is
descending during
cut.