Hyd-Mech H-22A, Operation And Maintenance Manual

Page: 22 / 130

Pg 2.7
H22
SINGLE PART CYCLE OPERATION
In MAN mode, the PLC allows the operator to initiate a "Single Part Cycle " to cut one piece at a desired length.
To accomplish this, follow the procedure below. Before initiating this procedure, the head should be "HOMED". See
function button description for
.
1) A trim cut should be made before initiating the "Single Part Cycle " operation.
2) Make sure the fixed vise switch (and the auxillary vise switch if used) is in the closed position.
3) Make sure the head is set so that the blade is above the material and the head selector switch is in the
HOLD position.
4) The cursor will be flashing at the CUT position. Key in the desired value from 0" to 220" and press
If the value is incorrect, re-enter the value and press
5) If the blade is not running, you will be prompted by the word "BLADE" flashing on the display window.
Start the blade and adjust the blade speed as required.
6) You will then be prompted by the word "START" flashing on the display window to begin the cut. Press
CYCLE START and the cycle will begin.
7) When the start button is pressed, the shuttle vise will move to the forward home position before executing
the length movement. The head will descend and make the cut.
8) When the cut is completed, the blade will stop, the head will rise to the previous head height setting and
the display window will reset for the next cut.
9) To cut another piece, repeat steps 2 through 6.
NOTES: 1) To "PAUSE" the "SINGLE CUT CYCLE", depress the "CYCLE START" button. The "CYCLE
START" button will begin to flash and the screen will indicate a paused condition. All
movements will immediately cease. To continue the cycle, depress "CYCLE START" button again.
2) To cut multiple pieces, switch to AUTO MODE and follow the automatic procedures.
SFM 0 CUT 1 0.250 LENGTH
LTH 0.000
SFM 100 CUT 1 0.250
LTH 0.000 START FLASHING
SFM 100 CUT
LTH 5.000 FR 1.2
SFM 0 CUT 0.000
LTH 0.000
KERF
ENTER
ENTER
BLADE SPEED SFM 0 CUT 1 0.250
LTH 0.000 BLADE FLASHING