•
Choose a suitable location to mount the tap, this may be an existing hole in your sink
or countertop.
•
If a new hole is required check that the reach of the spout will be appropriate for your
sink before drilling the tap hole in the sink or worktop. The required hole diameter is
32 mm - fits in a standard sink.
•
If installing in a Zen Font with Drain use the template supplied with the Zen Font to
establish tap hole position.
•
The tap can be installed onto sink/countertop up to 50 mm thick.
•
Place tap into hole, ensure the black o-ring is above the worktop. See Diagram 2.
•
Place the steel washer onto the threaded section of the tap under worktop/ sink.
•
Lastly screw the brass locking nut onto the threaded section. This will secure the tap
in position.
Step 1 - Prepare and Site the Tap
8