3
Transport and Installation
Page 3-18
InoFlex
®
VF016 - VF026
© Copyright
Edition C
HWR Spanntechnik GmbH
EN
3.3.2
I
NSTALLATION OF THE
I
NO
F
LEX
®
CENTERING VICE
(
EXAMPLARY
)
Note
This is an examplary installation. The exact procedure can vary in the indi-
vidual case. If need be please see the installation instructions provided by
HWR Spanntechnik.
Note
The InoFlex
®
centering vice can be installed on the machine table of the
machine tool directly.
Step 1
Clean the surface of the machine table or the QuickPoint plates
and of the bottom surface of the centering vice. There must not
be any debris or swarf on any of the surfaces.
Step 2
With the help of the hoist carefully and slowly guide the clean
centering vice (1) to the machine table (7) of the milling ma-
chine.
Step 3
Put a centering bolt (5) into the lower housing of the InoFlex
®
centering vice (1) and bolt together the centering bolt with the
corresponding fastening bolt (6).
Step 4
Place a locating sliding block (3) into the corresponding slot of
the lower housing of the InoFlex
®
centering vice (1) and bolt to-
gether the sliding block with the corresponding fastening bolt
(4).
Step 5
Lower the InoFlex
®
centering vice (1) on the machine table (7).
The centering vice (1) is being aligned via the centering bolt (5)
and the locating sliding block (3).
Step 6
Fasten the InoFlex
®
centering vice (1) on the machine table (7)
with clamping claws (2).
Note
Observe the maximum tightening torque for clamping claws.
Step 7
Remove the hoist and the eyebolt from the InoFlex
®
centering
vice (1).
Attention
The InoFlex
®
centering vice must not be distorted.
Summary of Contents for InoFlex VF016
Page 8: ......
