Title
Rev.
Page
HP-283 Technical Manual
Ver1.01
P.80
9. Wi-Fi setting
9-1) Initial setting
Initial setting is required before using the Wi-Fi interface.
The necessary process for using the Wi-Fi interface is expressed in the flow chart below.
The advantage of this printer that it is easy and simple to configure the Wi-Fi settings and use it right away.
(
※
When using WiFi, there will be 1 row of blank printed in case of Socket Open and Socket Close.)
Had initial setting been made?
Preparation
Had network operation
environment been used?
Turn on printer
Network is connected automatically.
Ready to use
(Power on by Dip1 SW3)
Strat setting mode (AP Mode)
Did the connected network IP
print?
Standby
Start the provided network setting
program (Ethernet_Config.exe)
Connect
network
with
printed
IP
information, enter network configuration
information
to
be
used,
and
start
configuration
Select fixed IP or DHCP IP by Dip SW, and
then set booting mode with User Value, Wi-Fi
mode with Print mode (Station Mode), and
then reboot
Connected successfully?
Standby
Open wireless network access point in
PC, select HWASUNG_xx:xx:xx for
connection, enter password (12345678)
and then Yes
YES
NO
YES
NO
YES
NO
NO
YES
(PE and ERROR LED blink)
(PE and ERROR LED blink)
*(See note 1)
See note 1
*(Note 1)
If it is not connected for more than
20seconds, check the network status,
then turn the printer off and back on.
(Both PE and ERROR LED blink
during connecting)