Poseidon2
– Family manual
HW group
www.HW-group.com
47 / 104
GSM SMS interface
Used for setting up the SMS sending parameters.
GSM Function
– Sets if the SMS messages will be sent through a local modem (available
only when serial port is in GSM modem state)
SMS+Ring when Alarm
– enables calling the target number during SMS sending
RS-232 GSM module
– Shows GSM modem status
o
Not Enabled
– inactive. Shows after changing the RS-232 port settings, until the change
is saved
o
Not Found
. Poseidon2 is set for connecting with local GSM modem, however the
modem was not found
o
Waiting for modem
– Searching for modem in process
o
Initializing
– Modem initialization in process
o
Ready
SMS center Number
– Control information, loaded from the SIM card, about provider's SMS
center number. If the number is not loaded, no SMS can be sent.
GSM SMS recipient section
Allows users to choose the recipient numbers for SMS messages - regardless the function mode
(local/remote modem)
SMS example
Device name:
Poseid11
Sensors in Alarm:
Rack11 = 48.5°C, threshold is 40°C
T-
Room = 48.3°C, threshold is 35°C
H-Room = 10% RH, threshold is 45% RH
Poseidon ALARM: Rack11(48,5), T-Room(48,3), H-Room(10)
Tip:
For a detailed description of the SMS format, see the “Using Poseidon units in your
programs” section.
Note:
Any changes must be confirmed by clicking the Apply Changes button. A successful
change is indicated by an animation in the status bar next to the Apply changes button.