6
CHANGES AND T YPING ERRORS RESERVED
CHANGES AND T YPING ERRORS RESERVED
CHANGES AND T YPING ERRORS RESERVED
2
2 MACHINE TRANSPORTATION AND
INSTALLATION
2.1 Machine dimensions
2.2 Transporting the machine
Unpack your machine carefully, and use a forklift
to set it in position. If a crane is used to lift the
machine, attach the lifting cable carefully to the
machine. Sufficient space should be left around
the machine to allow safe handling of materials,
inspection, and maintenance operations. Take
precautions to choose a location that will keep the
machine free of vibration and dust caused by other
machinery.
2.3 Minimum requirements for housing the
machine
- Main voltage and frequency must comply with
the machine’s motor requirements.
- Environment temperature should fall within
(-10ºC to + 50 ºC).
- Relative humidity cannot be over 90%.
2.4 Unpacking and Checking Contents
The Metal Saw is shipped complete in one carton.
Separate all parts from packing material and
check each item with illustration and “Table of
Loose Part” Make certain all items are accounted
for, before discarding any packing material.
WARNING:
If any parts are missing, do
not try to assemble the metal saw, plug in
the power cable or turn the switch on until
the missing parts are obtained and installed
correctly.
ITEM
TABLE OF LOOSE PARTS
Q’TY
A
Rear coolant return tray
1
B
Retrievable cover
1
C
Stop Rod Assembly
1
D
Instruction Manual
1
E
Tool box
1
2.5 Installing the rear coolant return tray
The rear coolant-return tray must be installed after
the machine is set in place. Install the coolant
return trays first.
- Installing three channeled L-bracket
Install three channeled L-bracket to the back of the
machine stand. Attaching the brackets requires 6
hex head bolt, 6 spring washers, 6 washers, and 6
nuts.
- Place a spring washer and washer on each hex
head bolt.
- Face the long side of the bracket up.
- Align the holes of short side of the bracket to the
machine panel’s holes.
- Place the 2 hex head bolts and their washers
through each bracket and machine panel.
- Use a nut on the inside of the machine stand to
secure each hex head bolt.
Summary of Contents for HU 331 DGH
