Hussmann CHINO TY3, Installation & Operation Manual

Page: 65 / 69

65
24 Manual RS8EP502 © Danfoss 12-2015 AK-CC 210
AD
AP
-K
OOL®
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alternations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respecitve companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Data
Supply voltage 230 V a.c. +10/-15 %. 2.5 VA, 50/60 Hz
Sensors 3 pcs off
either
Pt 1000 or
PTC 1000 or
NTC-M2020 (5000 ohm / 25°C)
Accuracy
Measuring range -60 to +99°C
Controller
±1 K below -35°C
±0.5 K between -35 to +25°C
±1 K above +25°C
Pt 1000 sensor
±0.3 K at 0°C
±0.005 K per grad
Display LED, 3-digits
External display EKA 163A
Digital inputs
Signal from contact functions
Requirements to contacts: Gold plating
Cable length must be max. 15 m
Use auxiliary relays when the cable is longer
Electrical con-
nection cable
Max.1,5 mm
2
multi-core cable
Relays*
CE
(250 V a.c.) UL ***
(240 V a.c.)
DO1.
Refrigeration
8 (6) A
10 A Resistive
5FLA, 30LRA
DO2. Defrost 8 (6) A
10 A Resistive
5FLA, 30LRA
DO3. Fan 6 (3) A
6 A Resistive
3FLA, 18LRA
131 VA Pilot
duty
DO4. Alarm
4 (1) A
Min. 100 mA**
4 A Resistive
131 VA Pilot
duty
Environments
0 to +55°C, During operations
-40 to +70°C, During transport
20 - 80% Rh, not condensed
No shock influence / vibrations
Density
IP 65 from front.
Buttons and packing are imbedded in the front.
Escapement
reserve for the
clock
4 hours
Approvals
EU Low Voltage Directive and EMC demands re CE-
marking complied with
LVD tested acc. EN 60730-1 and EN 60730-2-9, A1, A2
EMC tested acc. EN61000-6-3 and EN 61000-6-2
* DO1 and DO2 are 16 A relays. The mentioned 8 A can be increased up to 10 A, when the
ambient temperature is kept below 50°C. DO3 and DO4 are 8 A relays. Max. load must be kept.
** Gold plating ensures make function with small contact loads
*** UL-approval based on 30000 couplings.
Capacitive load
The relays cannot be used for the direct connection of capacitive loads such as
LEDs and on/off control of EC motors.
All loads with a switch mode power supply must be connected with a suitable
contactor or similar.