Husqvarna W50P, Operator'S Manual

Page: 14 / 224

The power of the engine is decreased
Cause Solution
The air filter is clogged. Clean or replace the air filter.
The fuel tank contains bad gasoline. Drain the fuel tank and the carburetor. Refer to
To drain
the fuel tank and carburetor on page 15 . Fill with clean
gasoline.
No fuel stabilizer has been added or the fuel tank has not
been drained before storage.
The engine speed is set to low. Increase the engine speed.
CAUTION:
Speak to an approved
servicing dealer if the problem stays.
There is no pump output or the pump output is decreased
Cause Solution
The location of the product is incorrect. Refer to
Installation on page 7
.
There is no water in the pump chamber. Refer to
To fill the product with water on page 8
.
The suction hose is damaged. Replace the suction hose.
The strainer is above the water surface. Put the strainer fully into water.
There is an air leakage at the hose connector. Replace the sealing washer if it is damaged. Tighten the
hose connector and hose clamp.
The strainer is clogged. Clean the strainer.
The strainer is damaged. Replace the strainer.
The level difference of the hoses is too high. Change the location of the product and/or the hoses.
The hoses are damaged or too long. The hoses has an
incorrect diameter.
Select the correct hose for the operation. Refer to To se-
lect the correct hoses for the operation on page 6
.
The power of the engine is decreased. Refer to
The power of the engine is decreased on page
14 .
Transportation and storage
Transportation
• Let the product become cool for a minimum of 15
minutes before transportation.
• Keep the product on a level surface during
transportation to prevent fuel leakage.
• Make sure that the fuel valve lever is in the OFF
position.
To prepare the product for short-term
storage
The instructions that follow are applicable for a storage
period of 30-90 days.
• Stop the product fully. Refer to
To stop the product
on page 10
.
• Drain the pump chamber.
14 1421 - 004 - 09.07.2020