Husqvarna TS 60, Operator'S Manual

Page: 14 / 80

14 –
English
OPERATING
Personal safety
• Never use the machine if you are fatigued, while under the
influence of alcohol or drugs, medication or anything that
could affect your vision, alertness, coordination or
judgement.
• Check that no tools or other objects have been left lying
on the machine.
• Never allow anyone else to use the machine without
proper training.
• Always shut off the machine during longer work breaks.
• Never work alone, always ensure there is another person
close at hand.
• Learn how to use the machine and its controls safely and
learn to how to stop quickly. Also learn to recognize the
safety decals.
• Keep handles dry, clean and free from oil and grease.
• Do not overreach. Keep proper footing and balance at all
times.
• Never stand on the machine.
• Stand upright. Keep distance between your face and the
cutting blade. Place both hands on the work piece as far
away from the cutting blade as possible. If plunge function
is used is one hand placed on the cutting handle.
Use and care
• This machine is designed and intended for cutting tile and
stone. All other use is improper.
• Experience is very important when running the machine.
A skilled worker is highly recommended.
• The machine is intended for use in industrial applications
by experienced operators.
• Check that the machine is assembled correctly and do not
show any signs of damage.
• Always perform daily maintenance before starting the
engine. See instructions in the section "Maintenance".
• Do not overload the machine. Overloading can damage
the machine.
• The blade shall be intended for the material to be cut.
• If you are uncertain of what blade to use contact your local
service dealer.
• Keep tools sharp and clean in order to enable safer work.
• Keep all parts in good working order and ensure that all
fixtures are properly tightened. Replace all worn or
damaged decals.
• Never leave the machine unsupervised with the motor
running.
• Feed the work piece against the rotation of the blade only!
• Observe care when lifting. You are handling heavy parts,
which imply the risk of pinch injuries or other injuries.
Water cooling to the blade
• Water cooling through the blade guard should always be
used when miter cutting and when diagonal cutting 500
mm (20”) tile. The cut is longer than the cart and at the
start of the cut, the blade will not pick up any water from
the slot in the cart.
• Turn the water knob slightly to redirect water to the blade.
• When reaching the slot in the cart, the water to the blade
can be shut off in order to keep the area as clean as
possible.