Husqvarna TS 510 G, Operator'S Manual

Page: 14 / 24

14
3. Check Before Operating
• Engine Fuel: Check the engine operation manu-
al. Unleaded gasoline is recommended.
• Engine Oil: With the Frame Assembly (1) posi-
tioned so that the engine is in a horizontal posi-
tion, check that the engine oil level is correct.
Check the oil level frequently to ensure that
the level never falls below that specified in the
engine operation manual. If the oil level is low,
add SAE 10W30, service classification SF or SG
oil (for normal conditions) as recommended in
the engine operation manual. DO NOT overfill
engine with oil!
Moving the machine:
The machine can be moved two ways:
1. By using the Lift Truck Brackets (43), a fork
truck can be used to lift the machine. Simply
slip one fork through the brackets on the front
lower part of the Frame Assembly (1).
Take into account the working condi-
tions from a health and safety point of
view.
Make sure that the Water Pump (4) is disengaged
before starting the engine. If it is not in the position
shown above, loosen the Water Pump Knobs (5)
and push all the way to the left (belt Guard moved
for clarity purposes only).
Blade Depth Stop:
This machine is equipped with an adjustable stop
that prevents the Blade (6) from cutting into the
Conveyor Cart Assembly (). The Depth Stop (45)
4
5
blades are to be used, the depth stop must be set
for 14” (350mm) blades. The depth stop will not
function properly for 18” (450mm) blades because
the blade will cut into the Conveyor Cart Assembly if
the operator does not take care.
DEPTH STOP ADJUSTMENT
0
14”
(355,6mm) (508,0mm)
20”
14”
20”
20”
14”
14”
45
45
To adjust the depth stop for a new blade diameter,
remove the attaching hardware, move the Depth
Stop (45) to the desired position, as shown above,
then re-install the attaching hardware.
. By using the Lifting Eye (4), a lifting sling
can slipped through the Eye, and along with a
lift truck or a crane, the machine can be eas-
ily moved. The Cutting Head Assembly (8)
should be lowered as much as possible to avoid
hitting the lifting sling when the machine is
lifted.
42
CAUTION!
DO NOT run Water Pump (4) for extended periods
of time without water! Water Pump (4) could be
damaged!
CAUTION!
Engine inclination angles greater than 0 degrees
could cause severe engine damage and void your
engine warranty!