Husqvarna TC 85 2017, Owner'S Manual, Page: 46 / 98

11 SERVICE WORK ON THE CHASSIS
44
E00219-10
–
Remove screw  .
–
Pull the main silencer off of the manifold at rubber sleeve

.
11.29 Installing the main silencer
E00219-11
–
Mount the main silencer with rubber sleeve

.
–
Mount and tighten screw

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
11.30 Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over a period, the fibers of the glass fiber yarn vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
Preparatory work
–
Remove the main silencer. ( p. 43)
401544-10
Main work
–
Remove screws

. Take off silencer cap

with O-ring

and outer tube

.
–
Pull glass fiber yarn filling

from the inner tube.
–
Clean the parts that are to be reinstalled.
–
Mount new glass fiber yarn filling

on the inner tube.
–
Slide outer tube

over the inner tube with the new glass fiber yarn filling.
–
Insert silencer cap

with O-ring

into the outer tube.
–
Mount and tighten screws

with toothed washers.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Install the main silencer. ( p. 44)