Husqvarna TC 85 2017, Owner'S Manual, Page: 26 / 98

9 SERVICE SCHEDULE
24
9.1 Additional information
Any further work that results from the required work or from the recommended work must be ordered separately and can be
invoiced separately.
9.2 Required work
Every 40 operating hours
Every 20 operating hours/after every race
Once after 10 operating hours / Every 10 operating hours
Check the front brake linings. ( p. 57)
○ ● ●
Check the rear brake linings. ( p. 62)
○ ● ●
Check the brake discs. ( p. 55)
○ ● ●
Check the brake lines for damage and leakage.
○ ● ●
Change the foot brake cylinder seals.
● ●
Check the rear brake fluid level. ( p. 60)
○ ● ●
Check the free travel of the foot brake lever. ( p. 59)
○ ● ●
Check the frame and swingarm.
● ●
Check the swingarm bearing.
● ●
Check the heim joints at the top and bottom of the shock absorber.
● ●
Check the tire condition. ( p. 67)
○ ● ●
Check the tire air pressure. ( p. 68)
○ ● ●
Check the wheel bearing for play.
● ●
Check the wheel hubs.
● ●
Check the rim run-out.
○ ● ●
Check the spoke tension. ( p. 68)
○ ● ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 49)
○ ● ●
Check the chain tension. ( p. 47)
○ ● ●
Grease all moving parts (e.g., hand lever, chain, ...) and check for smooth operation.
○ ● ●
Check the fluid level of the hydraulic clutch. ( p. 52)
○ ● ●
Check the front brake fluid level. ( p. 56)
○ ● ●
Check the free travel of the hand brake lever. ( p. 55)
○ ● ●
Check the play of the steering head bearing. ( p. 37)
○ ● ●
Change the gear oil. ( p. 76)
○ ● ●
Change the piston and check the cylinder. (under difficult operating conditions)
● ● ●
Check the clutch.
● ●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect rout-
ing.
○ ● ●
Check the antifreeze and coolant level. ( p. 69)
○ ● ●
Check the cables for damage and routing without sharp bends.
○ ● ●
Check that the throttle cables are undamaged, routed without sharp bends, and set correctly.
● ●
Clean the air filter and air filter box.
○ ● ●
Change the glass fiber yarn filling of the main silencer. ( p. 44)
●
Check the screws and nuts for tightness.
○ ● ●
Check idle.
○ ● ●
Final check: Check the vehicle for safe operation and take a test ride.
○ ● ●
Make the service entry in the
Husqvarna Motorcycles Dealer.net
and in the Service and Warranty Booklet.
○ ● ●
○
One-time interval
●
Periodic interval