29
1A.
oPeRAToR’S SeAT:
Operator seated here for
proper saw operation.
1B.
SPeeD ConTRol leVeR:
Forward advances
the saw Forward. Pulling the lever back reverses
the saw. Lever is spring-centered to neutral.
1C.
PARk BRAke SWiTCH:
Pushing down applies
park brake. Lift up to release and for operation.
1D.
BlADe ClUTCH SWiTCH (optional):
Engages
blade drive.
1e.
knoB (1 each side):
Allows steering wheel to be
tilted to the most comfortable operating position.
Secure both knobs before operating saw.
1F.
STeeRinG WHeel:
Turns rear wheel to maneuver
the saw.
1G.
WATeR VAlVe:
Controls flow rate to cool the
blade.
1H. FUel Fill:
Fill the fuel tank at this location.
1J. ReD PAlm SWiTCH:
For
emeRGenCY SToP
of the saw. Stops all systems except raise/
lower functions. Pull
oUT
to reset. Do Not use for
routine stopping.
1k. enGine TACH-HoUR meTeR:
Shows the engine
RPMs and hours of engine .
1l. RAiSe / loWeR SWiTCH:
Located on the speed
control lever. Use to raise and lower the saw. Push
up to raise the blade; push down to lower the blade
into the cut.
FiG. 1
1m. VolTmeTeR:
Shows the voltage of the electrical
system.
1n. WATeR TemP GAGe W/ enGine SHUTDoWn
1o. liGHT SWiTCH:
Pull switch up to turn on lights.
1P. WATeR SAFeTY SWiTCH:
Push switch down (OFF)
to bypass the water safety switch while starting
saw. Raise to up position during operation.
1R. enGine START SWiTCH:
Start and Stop the
engine using this switch.
1S. loW oil PReSSURe liGHT:
Lights up when
engine oil pressure is low and when key is on with
the engine not running.
1T. CiRCUiT BReAkeR mAin:
25 Amps. Push
to reset. Engine will not operate if circuit breaker
is protruding.
1U. CoVeR FoR ACCeSS To BATTeRY:
Provides
access to battery using rubber hood fasteners. Saw
shipped with Positive battery cable disconnected.
1V. WATeR inleT:
Connects to 3/4” garden hose for
fresh water supply through oil cooler to the blade.
1W. enGine THRoTTle:
Controls engine RPM. Push
red button to unlock. Pull out to increase; push
in to decrease RPM. Or, turn clockwise (CW) to
increase and turn counter-clockwise (CCW) to
decrease RPM.
1X.
SeRiAl no. DeCAl:
External Serial No Decal. A
second Decal is inside Battery Access Cover (1U).
Summary of Contents for RS 8500 D
