24 – English
TROUBLESHOOTING
Troubleshooting schedule
!
WARNING! If service operations or troubleshooting does not require the machine to be
on, the engine should be switched off, and the spark plug wire disconnected from the
spark plug.
Problem
Probable cause
Potential Solution
The machine
does not start
Incorrect starting procedure.
See instructions under the heading Starting and stopping.
Air filter clogged
Clean the air filter. Replace if necessary.
There is no fuel in the fuel tank
Refill with fuel
Spark plug defective
Replace the spark plug.
Spark plug cable disconnected.
Check that the spark plug wire is connected to the spark plug.
Loose blade or broken blade adapter
Tighten blade bolt or replace blade adapter.
Defect engine brake hommuuandle
Contact an authorized service workshop.
Fuel valve lever (if equipped) in OFF postion
Turn fuel valve lever to the ON position.
The battery voltage is too low (if equipped)
Charge the battery.
Battery connected incorrectly (if equipped)
Connect battery to engine
Less power
Height of cut too low.
Raise height of cut.
Cutting extremely tall grass
Air filter clogged
Clean the air filter. Replace if necessary.
Buildup of grass, leaves and trash under mower
Clean underside of mower housing.
Too much oil in the engine
Check the engine’s oil level
Walking speed too fast
Cut at slower walking speed.
Uneven mowing
Worn, bent or loose blade
Replace the blade if it is bent or damaged.
Wheel heights uneven
Set all wheels at same height
Buildup of grass, leaves and trash under mower
Clean underside of mower housing.
Excessive
vibrations
Worn, bent or loose blade
Replace the blade if it is bent or damaged.
Bent engine crankshaft
Contact an authorized service workshop.
Starter rope hard
to pull
Engine flywheel brake is on when the engine brake
handle is released
Depress the engine brake handle to upper handle before
pulling starter rope.
Bent engine crankshaft
Contact an authorized service workshop.
Blade adapter broken
Contact your service agent.
Incorrect starting procedure.
See instructions under the heading Starting and stopping.
Grass catcher not
filling (if
equippped)
Cutting height too low
Raise height of cut.
Worn blade
Replace the blade
Catcher not venting air
Clean / Inspect Grass Catcher
Difficult to push
the machine
forward
Cutting extremely tall grass
Raise height of cut.
Cutting height too low
Grass catcher too full
Empty the grass catcher
Handle height not right for you
Adjust handle height (if equippped)
Drive starts
feeling slow
Belt wear
See instructions under the heading Replacing the drive belt.
Belt off of pulley
Worn, damaged or untensioned clutch wire
For more information, see the ”Adjusting the clutch wire”
section.
