Husqvarna HUV4210 2005 Series, Maintenance Service Manual

Page: 36 / 60

BODY AND TRIM Rear Body and Fenders
Page 4-10 2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
4
REAR BODY AND FENDERS
See General Warning, Section 1, Page 1-1.
NOTE: The driver side rear fender can be removed without removing any other component. But the pas-
senger side rear fender cannot be removed without either removing the fuel tank, or removing the
rear body. It is easier to remove the rear body than to remove the fuel tank.
REAR BODY REMOVAL
1. Remove the seat from the rear body.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2. Remove cargo bed. See Cargo Bed Removal on page 4-6.
3. Remove seat back support brackets. See Seat Back Support Bracket Removal on page 4-9.
4. Remove the two screws, nuts and washers located at the bottom edge of the seat support panel (in kick-
plate just above the floormat) (Figure 4-13, Page 4-10) .
5. Electric vehicles:
5.1. Disconnect or remove charger receptacle:
5.1.1. Remove wire ties binding 10-gauge red wire (from charger receptacle to battery) to the
vehicle frame. Disconnect the 10-gauge red wire at the positive post of battery no. 1.
5.1.2. Remove the retaining nut and disconnect the 10-gauge black wire (from the onboard com-
puter) from the receptacle.
5.1.3. Unplug the fuse holder assembly to disconnect the gray sense lead from the receptacle.
Figure 4-13 Remove Kick-Plate Screws