BODY AND TRIM
Seat Back Support Brackets
Page 4-8
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
4
Bed Hinge and Support Bracket Removal
1. Remove steel bushings and urethane bushings from hinge brackets
(Figure 4-8, Page 4-8)
.
2. Remove bolts from hinges and remove hinges from supports.
3. Remove support channel bolts and bushings form hinge support channel
(Figure 4-9, Page 4-8)
.
4. Remove hinge support bolts and supports
(Figure 4-9, Page 4-8)
.
See following NOTE.
NOTE:
Note the location of the two different size bolts.
It may be necessary to deflect the rear fender slightly to remove support bolts.
BED LATCH ASSEMBLY INSTALLATION
1. Position latch link and catch plate assembly onto bed with support located at bolt holes and catch rods
positioned into bed slots.
2. Attach latch link with screws. Tighten hardware to 7 ft-lb (9.5 N·m)
(Figure 4-4, Page 4-7)
.
SEAT BACK SUPPORT BRACKETS
See General Warning, Section 1, Page 1-1.
NOTE:
The bed latch plates are a part of each of the seat back support bracket. Removing latch plates will
require adjustment for bed catch plates
(Figure 4-10, Page 4-9)
.
Figure 4-8 Bed Hinge
Figure 4-9 Hinge Support
Summary of Contents for HUV4210 2005 Series
