Husqvarna FR335, Workshop Manual

Page: 6 / 68

5
1
Starter
Assembly
Clean the component parts and assem-
ble in the reverse order as set out for
dismantling.
Assembly
Clean component parts before
assembling.
Replace the return spring/starter pulley
and starter cord, if necessary.
Lubricate the spindle with a little grease
and fi t the starter pulley.
Position the washer and tighten the
screw.
NOTE!
The return spring and starter pulley
are supplied pre-assembled and
are fi tted in the starter housing as a
single unit.
Exercise care when opening the
packaging so that the spring does
not fl y out.
Assemble the starter pulley.
Assemble a new starter cord.
NOTE!
A new starter cord can be fi tted
without the need of dismantling
the starter!
Assemble a new starter cord.
Assemble a new starter cord. Slide it
into the slot on the starter pulley as
shown in the picture.
Make sure that the knot at the end of the
cord is as small as possible and that it is
pressed in the starter pulley!
Assembling the starter
with a start assistance
spring
Clean the component parts and assem-
ble in the reverse order as set out for
dismantling.
Assembling the starter
with a start assistance
spring
Clean component parts before
assembling.
Replace the return spring/starter pulley
and starter cord, if necessary.
NOTE!
The return spring and starter pulley
are supplied pre-assembled and
are fi tted in the starter housing as a
single unit.
Exercise care when opening the
packaging so that the spring does
not fl y out.