Husqvarna FR335, Workshop Manual

Page: 5 / 68

4
1
Starter
502 50 18-01
502 50 18-01
502 50 18-01
!
WARNING!
Wear protective glasses.
The return spring lies tensioned
in the starter and can fl y out
and cause personal injury with
careless handling.
WARNING!
Protective glasses should be worn when working on the starter to avoid injury to the
eyes if, for some reason, the return spring should fl y out.
!
Dismantling
Model 336
Remove 2 of the screws holding the
cover under the engine against the
starter.
Loosen the 3 screws that hold the
starter in place and remove the starter.
The cylinder cover does not need to be
loosened or detached.
Dismantling
Model 333/335
Remove the 4 screws and carefully
swing down the protective plate so far
that the starter can be lifted out.
The cylinder cover does not need to be
loosened or detached.
NOTE!
Ensure the bushings that guide the starter towards the fuel tank are not lost.
The starter equipped with a start assistance spring is dismantled in the same way
as described above. However, to remove the screw in the centre of the starter pulley
requires a 5 mm Allen key, e.g. 502 50 64-01.
Remove the bolt in the centre of the
starter pulley and remove the starter
pulley. Remove the bolt in the centre of the
starter pulley. Lift the starter pulley care-
fully from the starter cover.
Loosen the spring tension. Loosen the spring tension.
Pull out the starter cord about 30 cm.
Brake the starter pulley with your thumb
and lift the cord as illustrated.
Let the starter pulley rotate backwards
slowly.