Husqvarna FR335, Workshop Manual

Page: 44 / 68

43
5
Angle gear
503 97 64-01
Drive axle
Dismantling
Dismantle the sleeve (B), the drive axle
and guide (A) to check for wear and
possible replacement.
Drive axle
Dismantling
The drive axle can be easily pulled out
of the shaft for inspection or replace-
ment.
The axle is guided with the help of a star
shaped, long guide (A).
Dismantle the sleeve (B) with the help of
a screwdriver or knife.
The guide (A) can now be pulled out of
the shaft for possible replacement.
NOTE!
Do not forget to fi ll the gear
housing to approx. 3/4 with gear
housing grease 503 97 64-01 once
the plug (D) has been removed.
Assembly
Clean all component parts and replace
if damaged or worn.
Fit the bearings on respective axles.
This is easier if the bearings are heated
to approx. 110°C using a hot air gun.
The bearings on the input axle are
sealed on one side. Turn the bearings
so this side faces outwards.
Heat the gearbox to approx. 110°C and
fi rst place the output axle in position and
then the input axle.
Make sure the bearing bottoms in its
seating.
Fit the circlips (B) and (C). Make sure
they lie correctly in their grooves.
Assemble remaining parts in the reverse
order as set out for dismantling.
NOTE!
Do not forget the circlip (A)
holding the bearing on the input
axle.
Dismantle the bearings from the output
and input axles.
Dismantle the bearings from the output
and input axles with the help of a small
bearing puller.
TIP!
Hold the bearing puller in a vice so that
it gains a better grip around the bearing.