Husqvarna FC 350 2023, Owner'S Manual

Page: 87 / 158

SERVICE WORK ON THE CHASSIS 11
85
H04933-10
–
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
1
.
–
Take off cover
2
with membrane
3
.
H04934-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
p. 144)
–
On the clutch slave cylinder, remove the protection cap and
mount bleeding syringe
4
with appropriate hose piece at
the bleeder screw
5
.
–
Only loosen bleeder screw
5
on the clutch slave cylinder to
the point where filling is possible.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
Avoid contact between brake fluid and painted parts.
Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
H04932-10
–
Now inject the liquid into the system until it emerges from drill
hole
6
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Tighten the bleeder screw and remove the bleeding syringe
with the hose. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the
screws.