Husqvarna FC 350 2023, Owner'S Manual

Page: 32 / 158

8 RIDING INSTRUCTIONS
30
8.6 Quickshifter (All FC models)
F03643-10
When the quickshifter is activated, you can shift up without actu-
ating the clutch.
Info
The quickshifter is not activated when shifting up from
first to second gear, and the clutch lever must be used
when shifting up instead.
Even if the quickshifter is activated, you need to use the
clutch lever to shift down.
Because there is no need to close the throttle grip, uninterrupted
gear shifts are possible.
The quickshifter uses the shifter shaft position to check whether
or not a shift should be initiated, and sends a corresponding sig-
nal to the engine control.
If the quickshifter is deactivated, the clutch needs to be actuated
in the normal way for each shift.
8.7 Activating the quickshifter (All FC models)
F03760-12
–
Press the QS button
1
to switch the quickshifter on or off.
The QS indicator lamp lights up when the quickshifter is
activated.
Info
The quickshifter is not activated when shifting up from
first to second gear, and the clutch lever must be used
when shifting up instead.
Even if the quickshifter is activated, you need to use
the clutch lever to shift down.
8.8 Shifting, riding
Warning
Danger of accidents If you change down at high engine speed, the rear wheel blocks and the engine
races.
–
Do not change into a low gear at high engine speed.
Info
If unusual noises occur while riding, stop immediately, switch off the engine, and contact an authorized
Husqvarna Motorcycles workshop.
First-gear is used for starting off and for steep inclines.
–
Shift into a higher gear when conditions allow (incline, road
situation, etc.). To do so, release the throttle while simultane-
ously pulling the clutch lever, shift into the next gear, release
the clutch lever and open the throttle.