WARNING:
Do not use a textile
detergent.
2. Flush the product with a large quantity of clear water.
3. Let the product become fully dry, away from sunlight,
fires or other heat sources.
WARNING:
Do not use the product
or put it in storage before it is fully dry.
To disinfect the product
WARNING:
Do not disinfect the
product more often than absolutely
necessary.
WARNING:
Only use disinfectants that
do not damage the synthetic material of the
product. We recommend isopropyl alcohol,
70%.
WARNING:
Obey the safety
instructions for the disinfectant.
1. Apply the disinfectant to the product surface.
2. Let the product become fully dry.
Service life of the product
The service life of a product without end connections is
a maximum of 10 years from the date of manufacture.
The service life of a product with end connections is
a maximum of 7 years from the day the product is
removed from the package. This is valid if the package
is not damaged and the product is removed from the
package at the time of the purchase.
The product must be discarded after a maximum of 10
respective 7 years of use.
Maximum service life can only be achieved if the product
is used not more than 1 week each year and kept in
storage correctly.
The actual service life depends fully on the condition of
the product. The condition of the product is affected by
these factors:
• UV radiation
• Type and frequency of use
• Product handling and storage
• Climatic influences such as ice or snow
• Operational environments such as salt or sand
• Chemical influences such as battery acid
• Heat contamination
• Mechanical deformation or distortion
Extreme conditions during operation can shorten the
service life to a single use only. If the product is
damaged before its first use, for example during
transportation, it must be discarded immediately and not
used.
Mechanical wear and sunlight decrease the service life
considerably. Bleached or abraded fibers, discoloration,
and hardened spots are signs that show that the product
must be discarded.
To take the product out of service
If the product is subject to a fall or shows signs of wear
or damage, it must be taken out of service.
1. If you are sure that the product is damaged, discard
it.
2. If you think that the product can be damaged, do
these steps:
a) Put a clearly visible label or marking on the
product to prevent accidental use.
b) Let a competent person or the manufacturer do
the required tests and inspections.
If the competent person gives a written approval, the
product can be used again.
Transportation, storage and disposal
Transportation and storage
• Before transportation and storage, make sure that
the product is clean and dry.
• Put the product in a bag that gives protection from
moisture, light and dirt.
• Put the product loosely in the bag. If the product is
made into a roll, it can twist and become damaged.
• Make sure that the storage space meets these
requirements:
• The temperature is 15–25°C.
• The air flow is sufficient.
• There is no sunlight, UV radiation or light from
welding equipment.
• There are no chemicals or other aggressive
environments.
• There are no objects with sharp edges.
Disposal
• Obey national regulations.
• Use the local recycling system.
1779 - 001 - 01.03.2022
7
