7. Lift the product by the handle until all 3 wheels are
on the floor.
8. Push the product slowly.
To engage and disengage the drive
wheels
The drive wheels are engaged when the locking pin is in
the inner hole and disengaged when the locking pin is in
the outer hole.
1. Tilt the product until the foot support and the handle
are on the floor.
2. Turn the wheels until the 2 holes are aligned and pull
out the locking pin.
3. Put the locking pin in the inner hole to engage the
drive wheels.
4. To disengage the drive wheels, put the locking pin in
the outer hole.
To move the product up and down a
ramp
WARNING:
Be very careful when you
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
For ramps with a steep
slope, always use a winch. Do not stay
below or near the product.
WARNING:
Do not move the product
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
• Do not turn the product more than 45° on a ramp.
To lift the product
WARNING:
Make sure that the lifting
equipment has the correct specification to lift
the product safely. The rating plate on the
product shows the product weight.
WARNING:
Do not walk or stay below
or near a lifted product. Keep bystanders
away from the risk area.
WARNING:
Do not lift a damaged
product. Make sure that the lifting point is
correctly installed and not damaged.
WARNING:
Do not lift the product by
the handlebar, motor or chassis.
1804 - 001 - 06.05.2022
21
Summary of Contents for BS 110
Page 119: ...1804 001 06 05 2022 119 ...