Husqvarna BS 110, Operator'S Manual, Page: 10 / 120

All available blade types can be used for the approved
materials: hardwood, ceramics, linoleum, vinyl, carpet,
adhesives and glue. Refer to
Blades on page 27
.
It is necessary to select correct dimension and
installation of the blade for the material to remove and
the subfloor type. Blades of different dimension can be
necessary during the same work operation.
• Select a blade of smaller dimension in these
situations:
a) At the start of an operation.
b) Operation on materials with strong adhesive.
c) Operation on hard materials.
• Select a blade of wider dimension in these
situations:
a) Operation on soft materials.
• Select a thicker heavy duty blade for hard materials.
A thicker blade also has a longer life.
• Install the blade with the bevel up for removal of
materials from concrete floors.
• Install the blade with the bevel down for removal of
materials from wood floors and soft subfloors.
To remove and install the weights BS
110
WARNING:
The weights are heavy.
1. Disconnect the power supply.
2. Remove the 2 nuts (A).
B
C
A
3. Remove the cover (B).
4. Remove the weights (C).
5. Install in the opposite sequence.
To connect a dust extractor
WARNING:
Do not use the dust
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Connect the dust extractor hose to the connection
for dust extractor. Refer to Product overview BS
75 on page 2
for information about where the
connection for dust extractor is on your product.
To connect the product to a power
supply
1. Connect an applicable extension cable to the power
plug of the product.
2. Connect the extension cable to a mains outlet.
To start the product
1. Start the dust extractor.
10 1804 - 001 - 06.05.2022