Problem
Cause
Solution
There is no control
voltage.
The emergency stop button is engaged.
Turn the emergency stop button clockwise to
disengage.
If the relay for the emergency stop button
has 3 green LED, the circuit is closed. Reset
the circuit breakers when they are off.
The operator presence control is engaged.
Install the key for the operator presence con-
trol.
The product does not
start when the start
button is pushed on
the control panel or
the keypad.
There is an error or "RDY" is not shown in
the display.
Do a check of the error messages on the
display. If "STO" or "PWR" shows in the dis-
play, there is no 24 Vdc to these inputs. Do
a check of the circuit of the emergency stop
button.
Error message on the display
1. If there is an alarm, select "Help" for cause and
possible solution.
2. The fault shows in the top left corner.
3. The solution shows in the display.
4. If the fault stays, stop the product. Refer to
.
5. Wait for 1 minute and start the product.
6. If the fault stays, speak to Husqvarna support.
Transportation, storage and disposal
Transportation
WARNING:
Be careful during
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
Do not tow the product
behind a vehicle.
• The wheels let you move the product shorter
distances. For longer distances, lift the product to
move it or put the product on a vehicle.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
To move the product manually with the
motor off
WARNING:
Wait until all moving parts
are stationary before you move the product.
WARNING:
Use protective boots with
steel toe-cap and non-slip sole.
WARNING:
Only move the product
manually on level ground.
1. Disconnect the product and remove the dust hose.
2. Push the product by the handles.
34
1823 - 003 - 13.04.2022
Summary of Contents for BB 700
Page 79: ...1823 003 13 04 2022 79 ...
