Maintenance
Daily
Weekly
Monthly
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
X
Do a check of the stop switch to make sure that it works correctly.
X
Make sure that the cutting attachment does not rotate at idle speed.
X
Clean the air filter. Replace if necessary.
X
Examine the cutting attachment guard for damages and cracks. Replace the
guard if it has been exposed to impact or is cracked.
X
Examine the trimmer head for damages and cracks. Replace if damaged.
X
Make sure that the screws and nuts are tight.
X
Examine the engine, the fuel tank and the fuel lines for leaks.
X
Clean the cooling system.
X
Examine the starter and the starter rope for damages.
X
Examine the vibration damping elements for damages and cracks.
X
Clean the outside of the spark plug. Remove it and do a check of the electrode
gap. Adjust the gap to the correct distance (see,
page 16
) or replace the spark plug. Make sure that the spark plug is fitted with
a suppressor.
X
Clean the outside of the carburettor and the space around it.
X
Do a check of the bevel gear to make sure that it is filled three-quarters with with
lubricant. Use special grease to fill if neccessary.
X
Clean or replace the spark arrestor mesh on the muffler (only applies to mufflers
without a catalytic converter).
X
Do a check of the fuel filter for contamination and the fuel hose for cracks or oth-
er defects. Replace if neccessary.
X
Do a check of all cables and connections.
X
Do a check of the clutch, clutch springs and the clutch drum for wear. Replace if
neccessary by an autorized service workshop.
X
Replace the spark plug. Make sure that the spark plug is fitted with a suppres-
sor.
X
Check and clean the spark arrestor mesh on the muffler (only applies to mufflers
without a catalytic converter).
X
To adjust the idle speed
1. Make sure that the air filter is clean and the air filter
cover is installed.
14
1003 - 001 - 07.01.2019
Summary of Contents for 525 LX
