Husqvarna 525 LX, Operator'S Manual

Page: 12 / 32

cracked. Replace if they are exposed to impact or
cracked.
WARNING: Do not use the product without a
guard or a guard that is defective.
To prepare the product for start
1. Push the air purge bulb again and again until the fuel
starts to fill the bulb.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control to the choke position.
WARNING: If the choke is in choke
position when the engine starts, the
cutting attachment starts to rotate
immediately.
To start the product
WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
Safety on page 4
).
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.
About the surface
WARNING: Do not touch the cylinder cover
or the muffler cover when the engine
operates. The covers are hot and can cause
burns to the skin. If the spark plug cap is
damaged, it can also cause electrical
shock . Do not use a product with a
damaged spark plug cap.
12 1003 - 001 - 07.01.2019