18 SERVICE WORK ON THE ENGINE
97
» If the engine oil is not at a level between lower edge
and middle
of
the level viewer:
–
Add engine oil. (
18.3
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding
Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preparatory work
–
Park the motorcycle on a level surface.
–
Remove the engine guard. (
B01769-10
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
with the magnet and seal ring.
Info
Do not remove screws
on both sides.
B01770-10
–
Remove screw plug
with oil screen
and the O-rings.
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
B01771-10
–
Position oil screen
with the O-rings on a pin wrench.
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
B01772-10
–
Mount and tighten screw plug
with the O-ring.
Guideline
Screw plug, oil screen
M20x1.5
15 Nm (11.1 lbf ft)
–
Mount and tighten oil drain plug
with the magnet and a new seal ring.
Guideline
Oil drain plug with magnet
M12x1.5
20 Nm (14.8 lbf ft)
Summary of Contents for 2016 FE 250
Page 1: ...OWNER S MANUAL 2016 FE 250 Art no 3402063en ...
Page 2: ......
