Attach Correct Hoop
When the size of the hoop on the machine does not match
the size displayed on the graphic display, your machine will
not sew. Change the hoop to the size displayed or change the
setting for hoop size to match your selected hoop, see Hoop
Size, page 69.
Check Upper Thread
Your machine stops automatically if the top thread runs out
or breaks. Re-thread the top thread and close the pop-up
message by pressing the OK button. Press the start/stop
button to continue.
Cut Thread End
When starting to embroider or after changing the thread, the
machine will sew a few stitches and then stop so you can cut
the thread end.
Note: This function is cancelled if the automatic stop for cut function is
deselected in the SET menu, see Automatic Stop for Cut (Only in
Embroidery Mode), page 30.
Change Thread Color
When it is time to change the needle thread the machine
stops and the threads are cut. Change the spool and re-thread
the machine. The next recommended color is shown in the
popup message.
This popup message is also shown when your machine stops
automatically for you to trim the fabric on cut work, applique
etc. See explanation for each design in the DESIGNER
JADE™ 35 sampler book.
Read about the sampler book on page 59.
Design Includes Elements That Cannot Be Opened
Some designs may contain data that is too complex for this
embroidery machine. Please use the downloadable software
to re-save the design, see Complimentary Embroidery Intro
Software (PC), page 24.
Remove the Hoop
This pop-up will appear when a function has been chosen
that forces the embroidery unit to move outside the limits for
the attached hoop. In order for the embroidery arm to move
freely, remove the hoop and then press the OK button.
72
7 Embroidery Mode
Summary of Contents for Designer Jade 35
Page 1: ...User s Guide KEEPING THE WORLD SEWING ...
Page 82: ......
