Thread Sensor
If the upper thread breaks, the machine stops and a pop-up
message appears on the graphic display.
Re-thread the machine and close the pop-up message by
pressing the OK button.
Lowering the Feed Teeth
The feed teeth are lowered when you move the switch on the
back of the free arm to the left. Move the switch to the right
if you wish to raise the feed teeth. The feed teeth will raise as
you begin to sew. The feed teeth should be lowered when
sewing on buttons and for free motion sewing.
Presser Foot Pressure
The presser foot pressure has been pre-set to the standard
value ”N”. In most cases, you do not need to adjust the
presser foot pressure. For specialty techniques, or when
sewing on very light or heavy fabric, adjusting the pressure
can improve the result. For very light fabrics, turn the dial to
a lower number. For heavy fabric, turn the dial to a higher
number.
Presser Foot Lift
The presser foot is lowered or raised with the presser foot lift
(A). If you are sewing on heavy fabric or several layers of
fabric, the presser foot can be raised higher (B) to make it
easier to place the fabric underneath the presser foot.
Note: The machine will not start when the presser foot is raised (except
for bobbin winding). A pop-up message will tell you to lower the presser
foot.
Changing the Presser Foot
Press the ON/OFF switch to “O”.
1. Make sure that the presser foot is raised and the needle is
in its highest position. Pull the presser foot towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle. Push back until the foot snaps into
place.
20
2 Preparations
Summary of Contents for Designer Jade 35
Page 1: ...User s Guide KEEPING THE WORLD SEWING ...
Page 82: ......
