Husky HU80220, Operator'S Manual

Page: 11 / 30

9 — English
ASSEMBLING THE SPRAY WAND
See Figure 6.


Push the two ends of the spray wand together so that
the holes inside each end are aligned.

Lower the locking collar and rotate counterclockwise until
you hear the clicking sound, which indicates the wand is
securely tightened.

Place the assembled spray wand in the spray wand holder
with the notched area resting on the generator handle.
ATTACHING THE HIGH PRESSURE AND LOW
PRESSURE HOSES TO THE SPRAY WAND
See Figure 7.

The low pressure hose is the clear tube with the plastic
fitting and goes on the spout at the bottom of the spray
wand.
 Grasp the plastic fitting and slide onto the spout until
it clicks into place.

To remove, depress the latch on top of the fitting and
remove the hose from the spout.

 The high pressure hose has a metal connection and slides
into the opening at the top of the spray wand.

Grasp the hose lock and pull outward to clear the way
for the high pressure hose to be inserted.
 Insert the high pressure hose all the way into the
hole.

Push the hose lock fully back into the handle to hold
the high pressure hose in place.
ASSEMBLY

CONNECTING THE GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 8.
The water supply must come from a water main. NEVER
use hot water or water from pools, lakes, etc. Before
connecting the garden hose to the pressure washer:

Run water through the garden hose for 30 seconds to
clean any debris from the hose.

Inspect the filter screen in the end of the pressure washer
intake hose.

If the screen is damaged, do not use the machine until
the screen has been replaced.

If the screen is dirty, clean it before connecting the
garden hose to the machine.
To connect the garden hose to the machine:

Uncoil the garden hose.
NOTE: There must be a minimum of 10 feet of unrestricted
garden hose between the pressure washer intake hose
and the garden hose faucet or shut off valve (such as a
“Y” shut off connector).

With the garden hose faucet turned completely off, attach
the end of the garden hose to the coupler on the water
intake hose. Tighten by hand.