21 HUSKYTOOLS.com
Please contact 1-888-43-HUSKY for further assistance.
ADJUSTING THE BELT TENSION
NOTICE
:
Once the engine pulley has been moved from its factory
set location, the grooves of the flywheel and pulley must be aligned
to within 1/16 in. (1.6 mm) to prevent excessive belt wear. Verify the
alignment by performing the
MOTOR PULLY/FLYWEEL ALIGNMENT
on
the following page.
□
Slide the motor into the original position, and
line the motor up with the mark made earlier on
the saddle.
□
Tighten the two outside motor mounting screws
enough to hold the motor in place for checking
the pulley and flywheel alignment.
□
The belt should deflect 1/4 in. (6.5 mm) at
midway between the pulley and the flywheel
when a ten-pound (4.5 kg.) weight is applied at
the midway point.
□
When proper belt tension is achieved, tighten all
motor mounting screws. Torque to 20-25 ft-lbs
(27.1–33.9 Nm).
Downw
ard For
ce
Deflection
Maintenance (continued)
