OPERATING INSTRUCTIONS
C
CU
UT
TT
TIIN
NG
G::
MAINTENANCE AND INSPECTION
5
http://www.huskietools.com
R
RIIG
GH
HT
T
W
WR
RO
ON
NG
G
1. Daily maintenance is required to ensure that the tool is kept in good working condition.
2. Sharpen blades occasionally with a sharpening stone on the back side of the blades to remove any
burrs that may occur.
3. Do not store the tool in a humid environment.
4. Wipe away any excess oil with a soapy cloth.
5. Provided that maintenance of the tool is carried out regularly, the tool should provide many years of
service.
6.
Should you experience any difficulty with the operation and maintenance of this tool, contact Huskie’s
technical support department at 1-800-860-6170.
5. Continue to advance the blades until the material is cut. If material is cut and tool has not yet
bypassed, it may be difficult to retract blades. If this occurs, continue to advance tool and build pressure.
A series of clicks will be heard while the tool running in a “neutral” mode. This indicates that the tool has
built full pressure and bypassed and can now be released.
1. Retract blades by pressing the release button.
2. Make sure that material being cut is within the specified cutting capacity of the tool.
3. Place the material to be cut between the blades and press the advance trigger until blades hold the
material in place.
4. Check material for proper alignment to the cutting blades. It should be at a 90° degree angle to the
blades. Any other angle will cause the blades to spread apart and possibly break.
