4
http://www.huskietools.com
A
AT
TT
TA
AC
CH
HIIN
NG
G T
TH
HE
E B
BA
AT
TT
TE
ER
RY
Y C
CA
AR
RT
TR
RIID
DG
GE
E
T
TR
RIIG
GG
GE
ER
R A
AN
ND
D R
RE
ELLE
EA
AS
SE
E B
BU
UT
TT
TO
ON
N
C
CH
HA
AR
RG
GIIN
NG
G T
TH
HE
E B
BA
AT
TT
TE
ER
RY
Y
1. The ram advances when the trigger is pressed and stops when the
trigger is released.
2. To retract the ram, press the release button. The ram continues to
retract while the release button is pressed.
1.
Insert the plug end into a 120V power source. The LED indicator
will flash red indicating the charger is now in “stand-by” mode
and ready to charge the battery. Do not plug the charger into a
generator as this will likely cause the fuse in the charger to short,
and will not operate.
2.
To charge a drained battery, insert the battery into the charger
until the LED indicator shows a steady green. This indicates the
battery is being charged and will be completed in approximately
25 minutes. The LED indicator will show orange when charging is
completed.
3.
If the indicator shows a steady red when the battery is inserted, the battery is too hot to be charged and
must be cooled to room temperature before charging. Do not leave the battery in the charger to cool
as the charger will not recognize the battery is inserted and will not charge.
4. If the LED indicator goes out or is flashing quick red, this could be a possible short in the battery
circuit, or a problem with the charger itself. It is best to consult the factory at 1-800-860-6170 for service
if such a condition occurs.
5. To recondition the battery, insert the battery into the charger and push the “R” button. The LED
indicator should be flashing green to indicate the discharge cycle is now in progress. The light will
turn steady orange when complete and the battery will have a full charge.
6. For technical questions or difficulty in operation, please call our
customer service department at 1-800-860-6170.
OPERATING INSTRUCTIONS
1. While pressing the latch, pull out the battery cartridge. To replace
the battery cartridge, push the new cartridge firmly into place.
2. After inserting a battery cartridge, check that it is securely in place
by pulling gently. Do not press the latch when pulling the cartridge.
