8
http://www.huskietools.com
TROUBLESHOOTING GUIDE
PROBLEM
CAUSE
SOLUTION
MOTOR RUNS, BUT THE TOOL
JAWS WILL NOT ADVANCE
Insufficient Hydraulic Oil
Consult Factory for Repair
Service
Air Block in Hydraulic
System
Invert tool to allow air to rise
towards the top of the oil
bladder
Defective Hydraulic Circuit
Consult Factory for Repair
Service
MOTOR RUNS, TOOL JAWS
ADVANCE BUT WILL NOT
BUILD PRESSURE
Insufficient Hydraulic Oil
Consult Factory for Repair
Service
Defective Suction Valve or
Bypass Cartridge
Consult Factory for Repair
Service
MOTOR WILL NOT RUN AT ALL
Defective Battery
Charge or Replace Battery
Bad Contact or Loose
Battery Connections
Check all Connections and
Wires
Misaligned Switch
Check to Make Sure that
Switch is Properly Aligned
with Trigger
Consult Factory for Repair
Service
TOOL JAWS WILL NOT RELEASE
Tool Did Not Complete a
Full Cycle and Bypass
Press Trigger and allow Tool
to Bypass. Then Release
Tool Jaws.
Connector is Jammed in
Tool Jaws
Press and Hold Release
Trigger While Prying Tool
Jaws Apart.
Release Trigger is Bent or
Misaligned
Consult Factory for Repair
Service
