12
2.
Extend cable assembly to its full length. Note how the existing cable is
connected to the drum.
3.
Remove old cable assembly and attach new one as the ld cable connected to
the drum. Insert the end of the new rope and secure the screw M8x10 being
tightly screwed
4.
Turning clutch to the
“CLUTH IN” position.
5.
Retract cable assembly onto drum, first five wraps being careful not to allow
kinking, then winch cable must be wound onto the drum under a load of at
least 10% rated line pull.
WARNING -
Only replace the wire rope with the identical replacement part
recommended by the manufacturer.
TROUBLE SHOOTING
SYMPTOM
POSSIBLE CAUSE
SUGGESTED ACTION
Winch does not
turn
-Electrical
connections
have
not
connected
properly
-Insert Switch Assembly all the way into
connector.
-Tighten nuts on all cable connections.
Motor runs but
Cable
drum
does not turn
- The clutch is Not
engaged
-Turn the clutch to the high or lows peed
position. If problem still persists, a qualified
technician needed to check and repair.
Winch
drum
runs slowly or
without normal
power.
-Insufficient pressure or
oil flow
- Insufficient fluid in the
system
-Bump is not suitable or defective. Change a
new one or a suitable one
-Check fluid level. Add fluid until full.
