- 11 -
LAP/LAP DISPLAY MODE
The lap number is shown at the top and the lap time in hours,
minutes and seconds at the bottom of the display.
If no lap time is stored or the motorcycle is driving, the LAP/LAP
mode will be skipped.
Hold the MODE button for 3 seconds in the SPEED/LAP mode to
clear the stored lap times.
+ button
changes to the next lap time.
– button
no function
press the MODE button to change to the next mode
press and hold the MODE button 3 seconds to change to the next
mode
SPEED/CLK (CLOCK) DISPLAY MODE
CLK will display time in hours, minutes and seconds.
+ button
no function
– button
no function
press the MODE button to change to the next mode.
press and hold the MODE button 3 seconds to set the time in the
menu (see SETTING THE CLOCK)
SPEED/H (HOURS) DISPLAY MODE
When you stop driving and no impulses are sent from the wheel
sensor, the display mode will automatically change from
SPEED/ODO to SPEED/H. H shows the operating hours. The ope-
rating hour counter starts to count as soon as you start the engine.
The displayed figure cannot be cleared.
Service intervals are indicated in operating hours for some
Husaberg offroad motorcycles, making the operating hour counter
a very practical function.
+ button
no function
– button
no function
press the MODE button to change to the next mode
press and hold the MODE button 3 seconds to change to the
SETUP mode (see REVEALING/CONCEALING functions).
SPEED/TRP1 (TRIP 1) DISPLAY MODE
The TRP1 trip meter is always active and counts to 999.9. It is used
to measure the length of a trip or the distance between 2 refueling
stops. TRP1 is linked to AVS1 and STP1. The calculation of these
figures is activated by the first impulse received from the wheel
sensor (when the front wheel starts to turn) and stops 3 seconds
after the last impulse is received (when the front wheel has stop-
ped). The TRP1, AVS1 and STP1 figures are automatically reset to 0
after passing 999.9.
+ button
no function
– button
no function
press the MODE button to change to the next mode.
press and hold the MODE button 3 seconds to automatically reset
the TRP1, AVS1 and STP1 figures to 0.
ENGLISH
OPERATION INSTRUMENTS
